Powerware (4080 KVA) 9390 User Manual download pdf (Page 26)

Installing the UPS System

3-4

Powerware

9390 UPS (40–80 kVA) Installation and Operation Manual S 164201535 Rev C

Rear Shipping Bracket

Pallet

Skid Bolts

(3 Places)

Removable Skid

Rear View

Shipping Bracket Bolts

Shipping

Bracket Bolts

Figure 3-2. Removing Rear Shipping Bracket on the Powerware 9390 UPS

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 205 206

(40–80 kVA) 1
IMPORTANT SAFETY INSTRUCTIONS 2
SAVE THESE INSTRUCTIONS 2
Consignes de sécurité 2
ClassAEMCStatements 2
Table of Contents 3
Section II – Operation 4
List of Figures 8
Powerware 10
Chapter 1 Introduction 11
1.2 Using This Manual 13
1.4 Safety Warnings 15
1.5 For More Information 16
1.6 Getting Help 16
Section I Installation 17
2.2 Preparing the Site 19
3.2 UPS Cabinet Installation 23
Installing the UPS System 24
Front View 25
Rear View 26
3.2.5.3 X-Slot Connections 33
Installation Checklist 35
Chapter 4 Batteries 39
4.2 Installing Batteries 40
EMERGENCY OFF 41
UNINTERRUPTIBLE POWER SYSTEM 41
Plug-In Terminal 45
Block J3 45
Section II Operation 53
UPS Cabinet 55
7.2.1 Single Module RT Modes 56
7.2.2 Normal Mode – RT 58
Understanding UPS Operation 59
7.2.3 Bypass Mode – RT 60
7.2.4 Battery Mode – RT 62
7.3.2 Normal Mode – Parallel 65
7.3.3 Bypass Mode – Parallel 66
7.3.4 Battery Mode – Parallel 68
7.4.1 Input Rectifier 69
7.4.2 Inverter 69
7.4.4 Bypass 70
7.4.5 Batteries 70
8.1 UPS Standard Features 71
8.1.7 Installation Features 72
8.2.3 HotSync Parallel System 73
8.2.4 Optional X-Slot Cards 73
8.2.5 Remote Monitor Panel 73
8.2.6 Relay Interface Module 73
PRESS ANY KEY TO CONTINUE 75
9.2.1 Mimic Screen 77
9.2.2 Event Screens 78
9.2.3 Unit Meter Screens 80
9.2.4 System Meters Screens 83
Meters screen 85
CONTRAST ADJUST 89
ENTER PASSWORD 91
CHANGE PASSWORD 93
MM/DD/YYYY 95
DD/MM/YYYY 95
TIME FORMAT SETUP 95
2702 2004 15 42 YES 96
SET DATE AND TIME MM/DD/YYYY 96
27 02 2004 15 42 YES 97
SET DATE AND TIME DD/MM/YYYY 97
COM PORT SETUP 98
System Controls Screen 100
Instructions.” 101
Load Off Screen 102
Reading the Status Indicators 103
Using the Control Panel 104
10.1SingleModuleOperation 105
UPS Operating Instructions 106
. The input and output 108
10.1.8 Charger Control 109
10.2.5 Single UPM Shutdown 115
Using Features and Options 120
11.4 Relay Interface Module 122
ON GENERATOR 123
12.1 General 125
12.2 System Event Horns 125
12.3 System Event Indicators 125
12.4 System Event Messages 125
Horn Phone Relay Log* 126
Indication 126
Log*RelayPhoneHorn 127
Responding to System Events 134
Chapter 13 Communication 135
13.3 Remote Notification 136
13.4 Terminal Mode 137
13.4.2 Event History Log 138
Communication 139
14.2.1 DAILY Maintenance 142
14.2.2 MONTHLY Maintenance 143
14.2.3 ANNUAL Maintenance 143
14.2.4 BATTERY Maintenance 143
Maintaining the UPS System 144
15.2.1 UPS System Input 145
Reduced for Generator 145
15.2.2 UPS System Output 146
¦1% (10% to 100% load) 146
15.2.3 Environmental 146
Product Specifications 147
Appendix A 149
Installation Information 149
DESCRIPTION: 150
DRAWING NO: SHEET: 150
REVISION: 150
208V INPUT AND 208V OUTPUT 154
480V INPUT AND 480V OUTPUT 154
SINGLE OR DUAL FEED 154
TYPICALPARALLELSYSTEM 156
(1+1 AND 2+0 CONFIGURATIONS) 156
(2+1 AND 3+0 CONFIGURATIONS) 157
(3+1 AND 4+0 CONFIGURATIONS) 158
TOP VIEW 175
BOTTOM VIEW 175
LEFT SIDE VIEW 176
RIGHT SIDE VIEW 176
TERMINAL DETAIL 178
INTERFACE TERMINAL LOCATIONS 182
INTERFACE TERMINALS 183
Hot Sync CAN Bridge Card 187
PARALLEL SYSTEM CAN WIRING 188
PARALLEL SYSTEM BACK UP 189
CONTROL (PULL CHAIN) 189
ALTERNATE PARALLEL SYSTEM 190
BACK UP CONTROL 190
(PULL CHAIN) WIRING 190
SUPERVISORY CONTACT MODULE 191
TERMINAL LOCATIONS 191
OPTIONAL REMOTE MONITOR PANEL 198
164201535---11 198
164201535---12 199
164201535---12 2 of 2 200
Warranty 203
*164201535C* 206

Comments to this Manuals

No comments

Powerware (4080 KVA) 9390 User Manual Page 26

Comments to this Manuals

Related products and manuals for Uninterruptible power supplies (UPSs) Powerware (4080 KVA) 9390