Powerware (4080 KVA) 9390 User Manual download pdf (Page 135)

13-1

Powerware

9390 UPS (40–80 kVA) Installation and Operation Manual S 164201535 Rev C

Chapter 13 Communication

This chapter describes the communication features of the Powerware 9390 40–80 kVA UPS

and provides information about connecting hardware and using Terminal mode.

13.1 X-Slot Cards

The Powerware 9390 UPS has a standard, factory-installed X-Slot communication bay with

two slots. An optional second bay is available, providing two additional slots. See Drawing

164201535 -8 starting on page A -33 for bay locations. The UPS is compatible with the

following X-Slot cards (see Figure 13-1):

쑺 Modbus Card - provides direct integration of UPS information (meters and status) to a

Building Management System (BMS) using the M odbus RTU protocol.

쑺 ConnectUPS-X Web/SNMP Card - provides remote monitoring through a Web browser

interface, e-mail, and a network management system using SNMP; connects to a

twisted-pair Ethernet (10/100BaseT) network. It has a built-in switching hub that allows

three additional network devices to be connected to the network without the

requirement of additional network drops. This card is provided as standard equipment

with the UPS.

쑺 Modem Card - provides “out-of-band” remote notification and monitoring using modem

communication directly to cell phones and pagers.

쑺 Relay Interface Card (AS/400) - has isolated dry contact (Form-C) relay outputs for UPS

status: Utility failure, Low battery, UPS alarm/OK, or On bypass when interfacing with

IBM

AS/400 computers, other relay connected computers, and industrial applications.

쑺 Industrial Relay Card (IRC)- is used to indicate the operating status of the UPS system

using the customer’s monitoring equipment. The IRC uses four isolated normally-open

or normally-closed dry relay contacts to indicate the UPS status. Normal, Bypass, Battery,

and Alarm mode can be monitored.

쑺 Hot Sync C omputer Area Network Bridge Card - provides connectivity for operational

mode control and metering of a parallel system at any UPM in the system. In addition,

this card can be used to connect optional system monitoring devices, such as a Remote

Monitor Panel, a Relay Interface Module, or Supervisory Contact Module, to the UPS.

LAN and telephone drops for use with X-Slot connectivity cards must be provided by

facility planners or the customer.

For installation and setup of an X-Slot card, please contact Powerware (see page 1-6). Refer

to the manual supplied with the X-Slot card for user instructions.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 205 206

No comments

Powerware (4080 KVA) 9390 User Manual Page 135