Powerware Ferrups FE/QFE 500VA User Manual download pdf (Page 29)

Powerware

FERRUPS FE/QFE UPS (500 VA–18 kVA) Installation Guide : Rev A www.powerware.com

CHAPTER 4

ELECTRICAL INSTALLATION

NOTE If you have a plug-receptacle unit, continue to “Battery Cabinet Installation” on

page 53 to install optional battery cabinets or to the startup section in the

Powerware

FERRUPS FE/QFE UPS (500 VA–18 kVA) User’s Guide

WARNING

Only qualified service personnel (such as a licensed electrician) should perform the

hardwired installation. Risk of electrical shock.

Before installing your UPS, complete the following information:

1. From the ID label on the UPS rear panel:

Model number:

Input voltage:

Output voltage:

2. From the bypass switch label:

Model number:

Internal or External?

Make-Before-Break (MBB) or Break-Before-Make (BBM)?

3. Verify that the UPS input and output voltages are what is

required for your application:

Does the input voltage for the UPS at the AC service panel

match the input voltage in Step 1?

Does the output voltage in Step 1 match the output voltage of

the equipment you are using with the UPS?

NOTE The FERRUPS provides single-phase power only.

4. If you answered NO to either question in Step 3, contact your

service representative or your local distributor for assistance.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

No comments

Powerware Ferrups FE/QFE 500VA User Manual Page 29