Powerware 5119 User Manual download pdf (Page 33)

Additional UPS Features

Powerware

5119 User’s Guide www.powerware.com

Network Transient Protector

The Network Transient Protector, shown in Figure 18, is located on the

rear panel and has jacks labeled IN and OUT. This feature

accommodates a single RJ-45 (10BaseT) network connector.

Low voltage models can also accommodate an RJ-11 telephone

connector that provides protection for modems, fax machines, or other

telecommunications equipment. As withmost modem equipment, it is

not advisable to use this jack indigital PBX (Private Branch Exchange)

environments.

Connect the input connector of the equipment you are protecting to the

jack labeled IN. Connect the output connector to the jack labeled OUT.

IN OUT

OUT

NETWORKTRANSIENTPROTECTOR

Figure 18. Network Transient Protector

Load Segments

Load segments are sets of receptacles that can be turned on individually

using powermanagement software. For example, during a power

outage, you can keep key pieces of equipment running while you turn

off other equipment. This feature allows you to save battery power. See

your power management software manual for details.

Option Modules

Option modules help your UPS communicate in a variety of networking

environments and are installed in the UPS option slot. See the manual

that accompanies each module for more information, or contact your

sales representative.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 41 42

No comments

Powerware 5119 User Manual Page 33