Powerware 5119 User Manual download pdf (Page 11)

Installation

Powerware

5119 User’s Guide www.powerware.com

3. On 230V models, plug the UPS power cord into the input

connector on the UPS rear panel.

Customer-supplied power cords must correctly rated for the

UPS (see “Specifications” onpage 29). You can also use the

power cord from the largest load if it is correctly rated.

4. Plug the UPS power cord into a wall outlet or power source.

The UPS conducts a self-test and enters Standby mode. If a red

Site Wiring Fault or Battery Service indicator stays on, see

Table 11 on page 33.

Site Wiring Fault Indicator

Battery Service Indicator

Figure 2. Fault Indicators

NOTE Lowvoltagemodelsmay notrecognize 50-Hzoutlets. If the UPS doesnot

startwhen connected to a 50-Hz outlet,unplugthe UPS.Pressand holdthe

button for3 seconds tostart theUPS onbattery andreconfigure thenominal

inputvoltageto either 100Vor 110V (see ”Configuration Mode”on page 15).Turn the

UPSoff. Wait for30 seconds.Then plugthe UPSinto theoutlet.

5. Plug the equipment to be protected into the UPS output

receptacles.

DO NOT protect laser printers with the UPS because of the

exceptionally high power requirements of the heating elements.

6. Start the UPS by pressing the On

button as shown in Figure 3.

The Power On indicator illuminates indicating that power is

available from the rear receptacles.

The installation is complete. To learnhow to operate the UPS,

see “Operation” on page 11. To change the factory-set defaults,

see “Configuration” on page 15.

NOTE The UPS charges to90% in approximately4 hours.However,it is

recommended thatthe UPScharge for24 hoursafter installation or long storage.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

No comments

Powerware 5119 User Manual Page 11