Operation
14
Powerware
®
5119 User’s Guide www.powerware.com
Load Level LEDs
The front panel displays the total load current or watts plugged into the
UPS (see Figure 13).
33-66% 5-33%66-100%
Figure 13. Load Level LEDs (Normal Mode)
Each LED represents 1/3 of a full load rating. Whenthe UPS is
approximately fully loaded (66-100%), all three LEDs illuminate. If the
load is 33-66% of UPS capacity, the third and fourth LED illuminate.
The last LED illuminates if the load is between 5% and 33%.
If any Load Level LEDs are red, see page 35 for more information.
Initiating the Self-Test
Press and hold the button for three seconds to initiate the self-test.
During the test, individual LEDs illuminate as various parts of the UPS
are checked.If the UPS finds a problem, an LED indicates where the
problem is. For more information, see “Troubleshooting” on page 33.
NOTE Allthree BatteryCharge LEDsshould belitand the UPS must not bein
Batterymode to performthe self-test.
Comments to this Manuals