Powerware 5115 RM User Manual download pdf (Page 33)

Installation

Powerware

5115 Rack-Mount User’s Guide : 164201449 Rev A www.powerware.com

Installing the UPS

The following steps explain how to install the UPS. See Figure 11 and

Figure 12 for t he UPS rear panels.

1. If you did not mount the UPS in a rack or to a wall, you can use

the UPS as a standalone unit by placing the UPS in a flat,

horizontal position.

2. If you are installing power management software, connect your

computer to the USB port or UPS communication port using

the supplied cable (see page 35).

NOTE If you need to change the factory-set defaults for the output voltage or input

voltage range, see “Voltage C onfiguration” on page 31 before installing the UPS.

3. Plug the equipment to be protected into the UPS output

receptacles.

DO NOT protect laser printers with t he UPS because of the

exceptionally high power requirements of the heating elements.

4. On 230V models, plug the detachable power cord into the

input connector on the UPS rear panel.

6-ft Power Cord with

5-15 Plug

Four 5-15 Receptacles

Site Wiring Fault

Indicator

Communication

Port

DIP Switches

Network Transient

Protector

USB Port

X-Slot

Communication Bay

Figure 11. 500–1500 VA, 120V Rear Panel

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 57 58

No comments

Powerware 5115 RM User Manual Page 33