Powerware 9 User Manual download pdf (Page 36)

Installation

Powerware

9PrestigeSeriesUser’sGuide (600 VA-1800 VA) www.powerware.com

2. Place the battery cabinets underneath or beside the UPS as

showninFigure3.

NOTE Forstacked cabinets,do not placemore than threebattery cabinetsin one

stack.The UPS cabinet must beplacedon top ofthe batterycabinets.

UPS

Cabinet

Battery

Cabinet

Air Vents

UPS CabinetBattery Cabinet

Stacked Cabinets Side-by-Side Cabinets

Figure 3. Cabinet Setup

3. Verify the circuit breaker on all battery cabinets is inthe

OFF (O) position (see Figure 4).

4. Plug the battery output connector on the battery cable into the

external battery connector on the UPS. All battery connectors

are polarized to prevent incorrect connection.

5. If additional battery cabinets are to be used, plug the battery

output connector of the second cabinet into the battery input

connector of the first battery cabinet. Follow this procedure for

each additional battery cabinet.

6. Remove the breaker tie or clamp from the circuit breaker on all

battery cabinets.

7. Switch the circuit breaker on all battery cabinets to the ON (

)

position.

8. If your UPS is a 120V unit, see the following section, “UPS

Startup for 120V Models.” If your UPS is a 208V-240V unit,

skip to “UPS Startup for 208V-240V Models” on page 32.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 69 70

No comments

Powerware 9 User Manual Page 36